What Is the Core Selection Logic Between Dry Granulation and Wet Granulation
Process selection for plant extract granulation centers on decisions across three dimensions: active ingredient stability, material physical properties and downstream production needs. The applicable boundaries of the two processes are very clear.
Dry Granulation: A Route Without Liquid or Heat for High-Activity Protection
Core principle: no water, ethanol or any other liquid binder is added throughout the process. High-pressure rollers of 30-100 kN directly press the extract powder into flakes. The flakes then go through crushing, sizing and screening to obtain finished granules.
Suitable plant extract types:
- Materials containing large amounts of heat-sensitive active ingredients, such as goji polysaccharides, Dendrobium alkaloids and volatile oil extracts. The high-temperature drying step is completely avoided. The retention rate of active ingredients can be increased by more than 20%.
- High-sugar extracts with strong hygroscopicity that easily deliquesce and cake on contact with water. No water contact occurs throughout the whole process. Material degradation and stickiness are avoided at the root.
- Pharmaceutical-grade extracts with strict requirements on solvent residue. No additional solvent is introduced. No subsequent residual removal process is required.
Process advantages: the production cycle is only about ten minutes. Power consumption per unit output is only 43% of wet granulation. There is no VOC emission. Environmental compliance costs are greatly reduced.
Limitation: there are requirements on the compressibility of the material itself. Pure fine-powder extracts need to be combined with 10%-15% excipients such as microcrystalline cellulose to improve formability. Otherwise the fine powder recovery rate will be relatively high.
Wet Granulation: A Classic, Mature Route with High Formability
Core principle: water, ethanol, starch slurry, HPMC or other liquid binders are added to the extract powder. A wet mass is made through high-speed stirring. Wet granules are formed by extrusion or fluid-bed spray agglomeration. Finally, heating and drying remove the moisture to obtain the finished product.
Suitable plant extract types:
- Fat-soluble flavonoids and free alkaloid extracts with poor adhesion and extremely loose powder. The granule forming rate is greatly improved through the liquid bridge action of the binder.
- Water-soluble polysaccharides and saponin extracts that are stable to water and heat, such as lily polysaccharides and ginseng saponins. Granules with very high sphericity can be obtained directly through fluid-bed one-step granulation.
- Compound blended extracts requiring high content uniformity. The CV value of particle size distribution in wet granulation can be controlled within 15%. Mixing stratification is completely avoided.
Sub-process selection:
- For high-viscosity, high-sugar extract powder, high-speed stirring wet granulation is preferred. The granule forming speed is fast. The granules are dense and concentrated.
- For solid beverage products with high solubility requirements, fluid-bed one-step granulation is preferred. Granulation and drying are completed simultaneously. Granule pores are uniform. No clumping occurs during reconstitution.
Limitation: the process has as many as 5-7 steps. Energy consumption in the drying step is high. The degradation risk of active ingredients sensitive to heat and moisture is significantly increased.

Precise Process Matching Table for Different Active Ingredients
| Core ingredient type of the extract | Recommended first-choice process | Core selection basis |
|---|---|---|
| Plant polysaccharides (goji, Dendrobium, lily) | Dry granulation / fluid-bed wet granulation | Protect heat-sensitive ingredients. Avoid high-temperature degradation |
| Free alkaloids, volatile oils | Dry granulation | Completely avoid water and heat. Prevent component volatilization and loss |
| Fat-soluble flavonoids, anthraquinones | High-speed stirring wet granulation | Improve the granule forming rate of loose powder |
| Compound multi-component blended extracts | Wet granulation | Ensure that content uniformity of the whole batch meets the standard |





